Malvern 1020 ръководство на потребителя

  • USER INSTRUCTIONS
    tentwenty & twentytwentysix
    CONDENSING BOILERS
    INFORMATION CONCERNING YOUR BOILER
    You are the owner of a Malvern High Efficiency Condensing Boiler and due to the
    way it works it will appear to produce a lot of steam from the terminal; this is harmless
    vapour and quite normal. The boiler requires a drain to be permanently connected,
    your installer has done this, it must not be disconnected or removed. The Installer
    should also have left you your Logbook. The Gas Safety (Installations
    and Use) Regulations makes it illegal for gas appliances to be installed or serviced
    by persons not CORGI Registered Operatives. All Registered Installers carry a
    CORGI ID card and have a registration number and this should be recorded in your
    Logbook. You can check your installer is CORGI registered by calling CORGI direct
    on:- 01256 372300
    IMPORTANT: DO NOT DISTURB APPLIANCE CASE.
    ELECTRICAL SUPPLY TO YOUR BOILER
    The boiler must be connected to a 230v ~ 50 Hz supply with a 3 Amp fuse rating.
    THE APPLIANCE MUST BE EARTHED.
    TO IGNITE YOUR BOILER
    With the Electricity supply switched on, the
    power
    lamp will be on. When the
    system programmer and thermostats are in a demand position and the front panel
    boiler thermostat fully clockwise, the boiler
    running
    lamp will be lit and the boiler
    will start automatically. The
    running
    lamp will go out when the system thermostats
    are satisfied or if the programmer is off.
    If the boiler fails to start and the
    lockout
    lamp is lit reset by turning the boiler
    thermostat to off then back on again.
    If the boiler does not start after using the reset allow the boiler to cool, then reset
    again. If this still does not succeed in getting the boiler to run, or if a fault is suspected
    turn the boiler and supply off and call the assistance of a Corgi registered Engineer.

Имате ли въпрос относно Malvern 1020?

Задайте въпроса, който имате за Malvern 1020 тук направо на други собственици на продукта. Дайте ясно и изчерпателно описание на проблема и Вашия въпрос. Колкото по–добре опишете проблема си и зададете въпроса си, толкова по–лесно другите собственици на Malvern 1020 ще могат да Ви дадат добър отговор.

Тук вижте безплотното ръководство за Malvern 1020. Прочетохте ли ръководството, но отговаря ли то на Вашия въпрос? Тогава задайте въпроса си на тази страница на други собственици на Malvern 1020.